Skip to main content

Full text of "Midmark M7 Timer Assembly Installation Instructions"

See other formats


MIDMARK 

INSTALLATION INSTRUCTIONS FOR TIMER ASSEMBLY 
USED ON THE MODEL M7 



YELLOW FROM HEATER ELEMENT 



FOR UNITS PRIOR TO SERIAL #: 

RB008107 CR001131 

CS001695 CPOO1062 

NOT INCLUDING UNITS WITH SERIAL #: 

RB007500 THRU RB007999 

INSTALLATION: 

1. Make sure power cord is unplugged. 

2. Remove all wires connected to the old timer. Remove timer knob and panel 
nut from front panel. The old timer should now be free for removal. 

3. Align threaded bushing and pin on front of new timer assembly with holes 
in front panel. Thread panel nut onto bushing^s shown, and tighten 
against front panel. 

4. Connect wires with new timer assembly as shown in diagram. Yellow buzzer 
wires are interchangable. 

5. Place original knob onto timer shaft on the front panel. 


Midmark Corporation, Versailles, Ohio 45380 U.S.A. 
937-526-3662 FAX 937-526-5542 

ALL PRODUCTS SUBJECT TO IMPROVEMENT CHANGES WITHOUT NOTICE! 
LITHO IN U.S.A. INDUSTRY CODE 0251 003-0635-00 (rev. B) 

COPYRIGHT BY MIDMARK CORPORATION - 1992 


BUZZER